FRONT BRAKES @ __5____MM REMAINING REAR BRAKES @ ___8__MM REMAINING
Perform a brake fluid as required by vacuuming out all the old fluid in the master cylinder and adding fluid to the master cylinder and bleeding all four corners until the fluid is clear.
SHOCK &/OR STRUT ASSEMBLY – Remove & Install or Remove & Replace – RWD Both,w/o Rear Air Suspension – [Includes: Bleed Brake System (where applicable). DOES NOT include disassemble or alignment (where applicable).]
Raul E. gave our service a 5 star review on 3/3/2023
Confirmed noise in front of vehicle. Noise would occur when going over bumps and turing right. Bounced suspenion over struts and would notice area around front left strut making noise. Whem bounced would feel a viberation on strut. Lifted vehicle and inspected suspenion conponents. Disconnected strut and noticed noise would still occur. With further inspection found the backing plate was barely rubbing with lower ball joint causing the noise concern. Reconnected strut and bent backing plate away from ball joint and test drove vehicle. On test drive no noise was heard again. The noise was being caused by backing plate slightly rubbing against ball joint. The repair was bending backing plate away from ball joint.
Sherry R. gave our service a 5 star review on 1/26/2023
Performed a charging system test. Found battery is good and needs a charge, found the alternator is not charging at the battery, tested on the back of the alternator and is not charging there as well, belts look good. Rec replacing the alternator then retest.
FRONT BRAKES @ ___04___MM REMAINING REAR BRAKES @ __04___MM REMAINING
Both rear latch assemblies are worn and that is why it is not opening up all of the way. These are not regular hood lifts. They have motor's built in them.
TRUNK / LIFTGATE SHOCK OR STRUT – Remove & Replace – Both
Replace front brake pad linings and machine front brake disc rotors. Clean and lubricate brake calipers and slide mechanisms. Check and fill brake fluid. Bleed air from system. Road test vehicle.
Replace rear shoes/Pads Install rear hardware, if necessary, machine drums or rotors, and adjust parking brake. Road test vehicle.
CABIN AIR FILTER – Remove & Replace
Cathy Q. gave our service a 5 star review on 9/16/2022
Vehicle does not crank. Performed battery test and passed. Tested and the started has power and ground when trying to crank. Manually turned the engine over to confirm it is not locked up. Engine also ha exessive oil leaks. Rec replacing starter then retest.
STARTER ASSEMBLY – Remove & Replace – V6
Vanessa H. gave our service a 5 star review on 8/28/2022
Performed inspection, found valve cover gasket leak's leaking. Recommend new valve cover gaskets and intake plenum gasket be replaced.
Performed inspection found no leaks in brake system. Tiny amount of air in system. Due to being intermitant issue suspect possible master cylinder internal leakage.
Brian and customer drove car and agreed that the noise is coming from something in the console area.
VALVE COVER GASKET – Remove & Replace – V6 Both
MASTER CYLINDER – Remove & Replace – [Includes: Bleed Brake System. NOTE: Deduct .4 when used in conjunction with any other Brake operation(s).]