Call (909) 391-3800

Go to…

Jeep

Home / Jeep / Page 2

We Service and Repair all Jeep cars

  • 2010 Jeep Commander

    Jeep Commander
    Mileage
    241,894
    Service Date
    1/25/2021
    Services Performed
    • THERMOSTAT HOUSING – Remove & Replace – V6
    • When we received the vehicle we found the water pump is broken and the belt is gone. we also found the lower radiator hose was off of the lower connection to the engine. We recommend a water pump, thermostat housing with thermostat, serpentine belt tensioner's and a new hose clamp on the lower radiator hose. Then start the vehicle and check for any head gasket issue's and advise. POST Repairs, we performed a head gasket testy and it passed at this time. We test drove about 8 miles and did not have any over heating issues. However we do hear some rod knocking type noise that could have been there before.
    • When we removed the water pump we found that the impeller had disintegrated. We did the best we could blowing out the debris from the cooling system but we are sure we did not get all of the debris!
    • Towing
     
    Dustin L. gave our service a 5 star review on 1/26/2021

  • 2006 Jeep Wrangler

    Jeep Wrangler
    Mileage
    103,889
    Service Date
    11/12/2020
    Services Performed
    • We tighten two pin's. One from the front and one from the back. Everything is working correctly at this time. If it will not hold we will have the to the fuse block. We found no power from the PCM to the transmission relay. We found a bad connection at connector #4 at the PCM. We applied dielectric grease and reconnected. It still has codes but the transmission is shifting through all gears. The vehicle still has two codes: PO218-High temp Operation Activated P1604-PCM internal Dual Port RAM Integrity failure.
     
    Mike N. gave our service a 5 star review on 11/30/2020

  • 2015 Jeep Wrangler

    Jeep Wrangler
    Mileage
    152,394
    Service Date
    11/17/2020
    Services Performed
    • We test drove the vehicle and verified the customers concern. We then scanned the computer and had the following codes; PO730-Incorrect Gear ratio P1731-Incorrect Gear engauged C121A-Steering angle sensor not initialized. We cleared the codes and checked for any shorted or pinched wires and could not find any at this time. In regards to the C121A- code we would need to further diagnose that problem. It could be a faulty clock spring but we would need to confirm that. For the transmission issue we recommend replacing the valve body first and then retest. Customer declined further repairs.
     
    Alexander C. gave our service a 5 star review on 11/17/2020

  • 2006 Jeep Wrangler

    Jeep Wrangler
    Mileage
    103,828
    Service Date
    10/29/2020
    Services Performed
    • Attach the stablizer on the right front as required.
    • We scanned the computer and have the following codes; PO714 PO218- Transmission codes. We tried scanning the PCM and it will not communicate with the PCM.It does have communication with the transmission and the instrument panel and air bags. We checked all grounds to the PCM and all power to the PCM. We then checked for wire continuity at DLC. After all of our testing we have determined that the PCM is faulty and should be replaced. Problem is the unit is discontinued.
     
    Mike N. gave our service a 5 star review on 10/29/2020

  • 2006 Jeep Wrangler

    Jeep Wrangler
    Mileage
    103,425
    Service Date
    9/23/2020
    Services Performed
    • Adjusted as requested.
    • We lifted the vehicle and test drove the vehicle and cannot find any problems with the front end at all.
     
    Mike N. gave our service a 5 star review on 9/23/2020

  • 2006 Jeep Wrangler

    Jeep Wrangler
    Mileage
    150,975
    Service Date
    9/1/2020
    Services Performed
    • FRONT BRAKES @ __06____MM REMAINING REAR BRAKES @ __07___MM REMAINING
    • THERMOSTAT – Remove & Replace – All Applicable Models
    • We scanned the computer and have the following codes: PO128-Coolant thermostat rationality. We recommend a new thermostat. The 02 Heater circuit has not run yet!
     
    Edger C. gave our service a 5 star review on 9/1/2020

  • 2006 Jeep Wrangler

    Jeep Wrangler
    Mileage
    150,635
    Service Date
    7/22/2020
    Services Performed
    • The front end checks out good.
     
    Edger C. gave our service a 5 star review on 7/22/2020

  • 2006 Jeep Liberty

    Jeep Liberty
    Mileage
    129,179
    Service Date
    4/7/2020
    Services Performed
    • Check for a coolant leak and advise.
    • FRONT BRAKES @ ___10___MM REMAINING REAR BRAKES @ __06___MM REMAINING
    • WATER PUMP – Remove & Replace – V6
     
    Kazem H. gave our service a 5 star review on 4/7/2020

  • 2006 Jeep Wrangler

    Jeep Wrangler
    Mileage
    64,875
    Service Date
    3/26/2020
    Services Performed
    • After our diagnosis we have3 determined that there is no ground relay control coming out of the computer. (PCM).
     
    Jay S. gave our service a 5 star review on 3/28/2020

  • 2006 Jeep Liberty

    Jeep Liberty
    Mileage
    119,910
    Service Date
    12/9/2019
    Services Performed
    • STOP LIGHT SWITCH – Remove & Replace – All Applicable Models
    • We scanned the computer and have the following codes: PO573-Faulty brake light switch circuit C2101-Battery voltage high-Stored C2115-Dynamics Sensor supply voltage high-Stored C2103-System Voltage High We then checked the battery and the battery itself is very low. We recommend a new battery and a brake light switch. Then clear the codes and recheck the charging system after repairs to make sure the alternator is charging correctly.
     
    Kazem H. gave our service a 5 star review on 12/9/2019