CRM Mitchell1

Home / Archives for CRM Mitchell1 / Page 5

We Service and Repair all CRM Mitchell1 cars

  • 2016 Toyota Highlander

    Toyota Highlander
    Mileage
    106,915
    Service Date
    6/14/2023
    Services Performed
    • FRONT BRAKES @ __8____MM REMAINING REAR BRAKES @ __8___MM REMAINING
    • Drain and refill the cooling system as required.
    • BRAKE SYSTEM – INSPECT – [Visually inspect brake linings/drums and brake pads/discs.] DRIVER'S FLOOR MAT – INSPECT – [Only use the driver's floor mat designed specifically for the model and model year of your vehicle. Always properly secure the driver's floor mat using the retaining hooks. Never install another floor mat on top of the existing driver's floor mat. Never install the driver's floor mat upside down.] FLUID LEVELS – INSPECT – [Inspect and adjust all fluid levels.] COOLANT – REPLACE – [Drain and flush the cooling system and refill with an ethylene-glycol type coolant. Inspect the radiator, condenser and/or intercooler for leaves, dirt and insects and clean if necessary. Inspect hoses and connections for corrosion and leaks. Tighten connections and replace parts as necessary. Initial replacement at 100000 miles/120 months. Replacement every 50000 miles/60 months thereafter.] ENGINE OIL & FILTER – REPLACE – [Reset the oil replacement reminder light ("MAINT REQD") or the message "OIL MAINTENANCE REQUIRED" on the multi-information display after maintenance at every 5,000 miles.] TIRES – ROTATE – [Check tire tread depth and for uneven or excessive wear.]
    • TRANSAXLE OUTPUT SEAL – Remove & Replace – Gas,FWD Right Side – [Includes: Confirm Fluid temperature for level check.] – [DOES NOT include alignment.]
     
    Don S. gave our service a 5 star review on 6/15/2023
  • 2015 Ford Focus

    Ford Focus
    Mileage
    113,426
    Service Date
    5/23/2023
    Services Performed
    • Battery dead, charged battery and tested okay at this time. Vehicle still would not start. Scanned and found multiple no communication codes with diffrent modules. Checked fuses and found mega fuse #9 broken. This fuse is the main fuse for the body control module, replaced the fuse and vehicle now starts, test drove vehicle and scanned no codes present at this time. All components are working normally at this time. Charging 14.3 volts.
     
    Rich O. gave our service a 5 star review on 6/8/2023
  • 2009 Chevrolet Malibu

    Chevrolet Malibu
    Mileage
    93,584
    Service Date
    5/3/2023
    Services Performed
    • MULTI-FUNCTION SWITCH – Remove & Replace – Switch Base Assembly,Bracket – [Includes: R&I Steering Wheel Air Bag Module.]
     
    Don S. gave our service a 5 star review on 5/4/2023
  • 2012 Chrysler Town & Country

    Chrysler Town & Country
    Mileage
    121,045
    Service Date
    4/25/2023
    Services Performed
    • Right engine mount is torn and the bracket is rubbing onto the mount rec replacing right engine mount then retest. Replaced engine mount and could no longer replicate the noise.
    • ENGINE OR TRANSMISSION MOUNT – Remove & Replace – Engine,Right Side
     
    Gilbert R. gave our service a 5 star review on 4/25/2023
  • 2018 Volkswagen Atlas

    Volkswagen Atlas
    Mileage
    50,825
    Service Date
    4/17/2023
    Services Performed
    • Check engine light on, P194A00 coolant pump rpm to high. P16C600 heater support pump dry running. Found coolant reservoir empty and coolant splashed all over the front of the engine, noticed water pump pulley is not aligned with the other pulleys. Added water and leaks badly without pressure. Rec replacing the water pump, t stat and belt to start. Clear codes, pressure test and block test to confirm no other cooling concerns. Vehicle also due for a oil service.
    • WATER PUMP – Remove & Replace – 3.6L Eng – [Includes: R&I complete Pump Assembly and separate Housing (where necessary).]
    • THERMOSTAT &/OR GASKET – Remove & Replace – 3.6L Eng – [Includes: Drain and refill Engine Cooling System.]
    • FRONT BRAKES @ __8____MM REMAINING REAR BRAKES @ __7___MM REMAINING
     
    Linda C. gave our service a 5 star review on 4/19/2023
  • 2014 Chevrolet Cruze

    Chevrolet Cruze
    Mileage
    79,726
    Service Date
    3/27/2023
    Services Performed
    • Pressure tested cooling system. Found the coolant expansion tank/reservoir having pinhole leaks. Also found water outlet housing is leaking. Recommend replacing coolant expansion tank and water outlet housing that is also leaking and requires replacement. After repairs retest cooling system with pressure test
    • WATER INLET – Remove & Replace – 1.4L Eng,Turbocharger w/Thermostat
    • RADIATOR RESERVE TANK – Remove & Replace – Surge Tank
     
    Linda P. gave our service a 5 star review on 3/27/2023
  • 2006 Chevrolet Silverado

    Chevrolet Silverado
    Mileage
    205,000
    Service Date
    3/23/2023
    Services Performed
    • P0332 knock sensor 2 signal short / low. Tied in a lab scope to the knock sensor harness and lightly tapped the engine. The scope showed the sensor would intermittently pickup the vibrations throughout the engine. Cause would be a faulty sensor or a poor connection, knock sensors are located under the intake manifold. Rec replacing both knock sensors with the harness, intake and throttle body gasket.
    • ENGINE KNOCK SENSOR – Remove & Replace – V8,4.8L Eng Both
     
    John A. gave our service a 5 star review on 3/23/2023
  • 2005 Toyota Camry

    Toyota Camry
    Mileage
    199,886
    Service Date
    3/17/2023
    Services Performed
    • We tried to verify the customer complaint but found the engine does not crank. We checked for power and ground at the starter and found both are present. We then manually supplied voltage to the starter solenoid and found the starter is internally shorted. These tests confirm that the starter is faulty. We recommend replacing the starter for further diagnosis of the engine ticking noise.
    • Replaced the starter assembly, vehicle now starts and a loud noise comes from the pulley area, also noticed no engine oil on dipstick and is low on coolant. Engine idle is low and runs rough. Added 2 quarts of blended 5w-30. Started vehicle and used my steathascope and all components driven by the serp belt make noise, the loudest is the water pump. Removed belt and noise goes away, use a mirror to inspect the bottom of the water pump and has very heavy tracing, water pump has been leaking for a while. Rec throttle body service and water pump, t stat and rad cap replacement to start. Vehicle will need attention in other areas.
    • Perform a throttle body service because the throttle body is dirty.
    • WATER PUMP – Remove & Replace – In-Line4
    • THERMOSTAT &/OR GASKET – Remove & Replace – In-Line4
     
    Nitin V. gave our service a 5 star review on 3/17/2023
  • 2016 Toyota Highlander

    Toyota Highlander
    Mileage
    102,770
    Service Date
    3/9/2023
    Services Performed
    • FRONT BRAKES @ __10____MM REMAINING REAR BRAKES @ __10___MM REMAINING
     
    Don S. gave our service a 5 star review on 3/10/2023
  • 2010 Toyota Sequoia

    Toyota Sequoia
    Mileage
    187,124
    Service Date
    3/3/2023
    Services Performed
    • FRONT BRAKES @ __5____MM REMAINING REAR BRAKES @ ___8__MM REMAINING
    • Perform a brake fluid as required by vacuuming out all the old fluid in the master cylinder and adding fluid to the master cylinder and bleeding all four corners until the fluid is clear.
    • SHOCK &/OR STRUT ASSEMBLY – Remove & Install or Remove & Replace – RWD Both,w/o Rear Air Suspension – [Includes: Bleed Brake System (where applicable). DOES NOT include disassemble or alignment (where applicable).]
     
    Raul E. gave our service a 5 star review on 3/3/2023